ID 226384 - NukeStudio/Hiero remembers old import settings for footage frame rate rather than updating to the current settings

Problem summary
When importing a clip into a project in a new NukeStudio session, the clip is imported at the sequence frame rate specified in the project settings. If the same clip is imported into a new project within the same NukeStudio session, the clip is still imported at the same frame rate it was the first time, even if the frame rate has changed in the Project Settings.

Frame rate setting is only remembered per session. When NukeStudio is closed and reopened, footage will be imported at the project's frame rate setting again, which is then remembered for the rest of the session.

Customer reported version
nuke.9.0v7

Customer reported platform
windows7

Steps to reproduce

1) Start a new NukeStudio project and note the Frame Rate in Project Settings > Sequence

2) Import some footage

3) Close the project and start a new one

4) Change the Frame Rate in Project Settings > Sequence

5) Import the same footage 

6) Frame rate of the footage will be set to what the old project is set to rather than be updated to the new one

Reproduced by support
Reproduced on Windows 7, Linux and MAC OSX El Capitan 10.11

Reproduced in NukeStudio 9.0v1, 9.0v8, 10.0v1, 10.0v3

Expected behaviour
The clip should be imported at the frame rate specified in Project Settings

Actual behaviour
The clip is always imported at the frame rate of the first project it was imported into in this Nuke session