ID 295044 - Editing strip width on a fusion item set to anything other than "draft" resets wireframe drawing

When you edit the strip width of a fusion item that is in any mode other than "Draft", wireframes appear on the mesh even if you've turned them off in the viewport options.

Steps to reproduce

-Create a fusion union between two meshes
-In the fusion item properties, set the Fusion Mesh Mesh Mode to Airtight Draft
-Click on the strip in the gl viewport to enable the strip channel hauling tool
-Change wireframes to something other than "Colored" in the viewport's active mesh properties.
-Change the strip width, note the wireframe resets to colored.

Workaround