ID 405541 - Procedural curves are not rendering their full length.

Problem summary
Procedural curves are not rendering their full length.

Customer reported version
Modo 13.1v1

Customer reported platform
Windows 10

Steps to reproduce

1) Create two separate locators and go to the Setup layout.

2) Select the Add button in the Schematic Viewport and add a Locators to Array node.

​

3) Connect the two locators to this node, now select Add again and add a Create Polygons.

4) Connect the Output of the Locators to Array node to the Positions channel of the Create Polygons node.

​

5) In the Properties of the Create Polygons node-set Mode to Fill, Closed to None and Polygon Type to Curve.

​

6) Now in the Items list select the Mesh node and then within its Properties select the Curve tab and enable Render Curves.

​

7) Create two spheres on the locator's position and press the F9 key to render, notice how the curve isn't rendered at its full length.

​

Expected behaviour

The rendered curve should reach both spheres.

Actual behaviour
The curve isn't rendered at its full length.

Workaround
Unknown. 

Reproduced by support

This bug has been reproduced in:
Modo 13.1v1 - Windows 10 - Centos 7 - MacOS 10.13

Modo 13.0v1 - Windows 10 - Centos 7 - MacOS 10.13

Earliest version tested

13.0v1 - This feature did not exist before this version.