When using different parts of a single source clip in Avid, then bringing the AAF into Flix with Hold First Frame, all panels relating to this clip will keep the first frame of the source, rather than the first frame given by the Mark In set in Avid.
Steps to reproduce
1) Publish a very short (for example 2 panels) Sequence Revision to Avid.
2) In Avid, add a .mov to the Bin, and set a Mark In and Out so that you only use the middle of it, and add this to the sequence from Flix (choose a .mov where it's easy to tell roughly which section of the video should appear in Flix).
3) Then set a different Mark In and Out, so you only use the last bit of the .mov, and add this to the sequence as well.
4) Publish this back to Flix using Hold First Frame.
Expected behaviour
There should be two reconformed panels, and two refs: one that shows the .mov's first Mark In set in point 2, and one that shows the second Mark In that was set in point 3.
Actual behaviour
There are two reconformed panels, and two refs, but they both show the first frame of the source .mov.